Linen Placemat Bag
By Connie Palmer, Husqvarna Viking/Martha Pullen Licensed Educator
 |
Supplies:
|
- Embroider desired initials in the blocks.
- Using 1/8 inch ribbon, run ribbon through the vertical and horizontal drawn thread areas leaving tails. (Not the one around the outside edge.)
- Place the plain and embroidered placemats wrong sides together. Pin around the edge, matching up the drawn thread around the outside edge. (The 2 drawn thread areas will not match exactly, just wiggle and fit.)
- Sew a straight stitch following the drawn thread around the outside edge catching the ribbon tails.
- Trim ribbon tails up to stitching.
- Measure the width of your handles.
- Find center of the top and mark half of the measurement of your handles on each side of the center mark. Do this for both sides of the purse top.
- Cut 4 pieces of the 5/8 inch wide ribbon 2 and 3/4 inch long for the loops.
- Fold each in half and pin in place between the 2 placemats at the handle marks, leaving 7/8 inch of loop above top edge of placemat.
- Sew through both layers across top, catching the ribbon loops as you sew.
- Fold placemat in half, right sides together, and sew down the sides, 1/4 inch to 1/2 inch from the edges.
- To box off the bottom, match up bottom fold with side seam and sew 1 and 1/2 inch from point.
- Turn bag right side out and hook handles in ribbon loops.
- Using 1/4 inch wide ribbon, cut 8 inch ribbon ties. Tie bows at random intersections of the hemstitching on the purse front.
|